On the origin of seismic signals recorded on Stromboli volcano

 

The main purpose of volcano-seismology concerns the qualitative and quantitative description of one or more unknown seismic source(s) located at some unknown depth beneath a volcano. Even if many different volcanoes show similar seismic signal characteristics, up to now it was not possible to find a standard seismic source model for volcanoes, as the double-couple in earthquake seismology. Volcanoes with a continuous activity, like Stromboli (Italy), represent for the volcano seismologist a perfect natural laboratory to address this question. The presentation treats the study of explosionquakes and volcanic tremor recorded on Stromboli in a broadband frequency range, and discusses the location and the possible mechanisms of the seismic source(s). Seismic and infrasonic recordings of explosion-quake from Stromboli showed that the high-frequency phase propagates with a velocity of approximately 330 m/s. The seismic source can be explained as an explosion at the top of the magma column generated by rising gas bubbles. The seismic P-wave and the air-wave are both generated in the same point at the same time. The different path lengths and velocities for the seismic wave and the air-wave result in a difference in arrival times Δt, that could be used to deduce the magma level and sound speed in the eruption column inside the conduit. Stations installed near the active crater reveal that infrasonic and seismic recordings of the short-period tremor (> 1 Hz) share the same spectral content and show similar energy fluctuations. Therefore, the short-period volcanic tremor at Stromboli originates from the continuous out-bursting of small gas bubbles in the upper part of the magmatic column. The spectrum of the long-period tremor recorded at Stromboli consists of three main peaks with periods at 4.8 s, 6 s and 10 s, and amplitudes varying with the regional meteorological situation. Hence, they are not generated by a close volcanic source but rather by ocean microseisms (OMS). The passage of a local cyclone seems to be the seismic source for spectral energy at 4.8 s and 10 s, which represent the Double Frequency and the Primary Frequency of the OMS, respectively. Concerning the 6 s peak, a cyclone near the British Isles could act as a seismic source. Seismic data from the first broadband array deployed on Stromboli showed surprisingly simple waveforms, indicating an initially contracting source mechanism. The analysis of particle motion and the application of seismic array techniques allowed the location of a seismic source in the shallow part of the volcano. Eruption parameters and seismic source characteristics of the April 5, 2003 Stromboli eruption have been estimated using different inversion approaches. The paroxysm was triggered by a shallow slow thrust-faulting dislocation event with a moment magnitude of Mw = 3.0 and possibly associated with a crack that formed previously by dike extrusion. At least one blow-out phase during the paroxysmal explosion could be identified from seismic signals with an equivalent moment magnitude of Mw = 3.7. It can be represented by a vertical linear vector dipole and two weaker horizontal linear dipoles in opposite direction, plus a vertical force. Seismic measurements performed during controlled and reproducible blow-out experiments with a gas volume entrapped in basaltic melt revealed the following: Monochromatic seismic signals suggest a blow-out in a more ductile regime, whereas broader frequency content indicates rupture in a more brittle environment. The longer the crucible, the weaker the seismic signals. An increase in pressure results in a stronger fragmentation, but not in a higher ejection velocity of the plug neither in a higher seismic amplitude. Even if the very long period observations like the tilt signal could not be simulated in the laboratory, the blow-out experiments simulate very well the short-period seismic signals recorded at Stromboli volcano